2016 GMC Canyon SLFACTORY OEM SERVICE PROCEDURE

Remote Control Door Lock Receiver Replacement

Fig 1: Remote Control Door Lock Receiver
GM3747626Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove the center reading and courtesy lamp assembly to gain access to the receiver. Refer to Center Reading and Courtesy Lamp Replacement .
1 Remote Control Door Lock Receiver

Procedure

  1. Disconnect the electrical connector and the remote control door lock receiver antenna.
  2. Release two tabs and slide the receiver rearward to release from bracket attached to headliner.
  3. For programming and set up, refer to Control Module References .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.