Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Radar Sensor Module - Long Range Calibration: Notes
"Adaptive Cruise Temporarily Unavailable" service message may be displayed if this calibration procedure has to be performed. The radar may have become misaligned.
After replacing and programming the Long Range Radar Sensor Module, it is necessary to perform a calibration procedure to align the radar. This is indicated to the technician by DTC B101E 4B. Calibration is performed while driving the vehicle with the scantool connected. Calibration is initialized using a scantool and the scantool must remain connected until calibration is complete. During this time the "Service Driver Assist" service message will be displayed. Once the procedure is complete, the service message will turn off and normal operation will resume.
Calibration is not required if the existing module was reprogrammed only. Calibration needs to be conducted if the module was replaced or removed and re-secured.
If calibration is not successful, it could be due to improper driving environment, module and bracket assembly bent out of position or incorrect module mounting. A typical driving environment is usually sufficient to calibrate the module within 10-30 minutes. The module needs to be mounting properly in the bracket and aimed straight ahead within +/- 3 degrees.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.