Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 GMC Canyon 2WD L4-2.9LFACTORY OEM SERVICE PROCEDURE
Heated Seat Control Module - Driver (KA1)
Passenger Compartment/Roof Component Views
Under the Driver Seat Components
1 - Seat Adjuster Motor Assembly - Driver (AG1)
2 - Seat Adjuster Switch - Driver X1 (AG1)
3 - Seat Adjuster Switch - Driver X2 (AG1)
4 - Seat Adjuster Motor Assembly - Driver Connector (AG1)
5 - Seat Lumbar Motor - Driver (AG1)
6 - X307 (AG1)
7 - X314
8 - Heated Seat Element - Driver Back (KA1)
9 - X319 (KA1)
10 - Seat Vertical Motor - Driver (AG1)
11 - Heated Seat Control Module - Driver (KA1)
12 - Seat Belt Buckle - Driver
13 - Inflatable Restraint Seat Position Sensor (SPS) - Driver
14 - Heated Seat Element - Driver Cushion (KA1)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
