Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 GMC Acadia AWD V6-3.6LFACTORY OEM SERVICE PROCEDURE
Steering Column Components
Instrument Panel/Center Console Component Views
Steering Column Components
1 - Steering Wheel/Column Tilt/Telescope Switch (N38)
2 - Turn Signal/Multifunction Switch
3 - Inflatable Restraint Steering Wheel Module Coil
4 - Theft Deterrent Module (TDM)
5 - Steering Wheel Speed/Position Sensor
6 - Ignition Lock Cylinder Control Actuator
7 - Ignition Switch
8 - Steering Wheel Tilt Actuator (N38)
9 - Steering Column Telescope Actuator (N38)
10 - X295
11 - Steering Wheel Tilt Position Sensor (N38)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.