2010 GMC Yukon Denali, AWDFACTORY OEM SERVICE PROCEDURE

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the appropriate DVD display.
  2. Ignition OFF, test for less than 5.0 ohms between the ground circuit terminals listed below and ground.
    • Ground terminal 6
    • Ground terminal 5 (DNU)
    • If greater than specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, DVD playing, test for B+ between the entertainment remote enable B+ circuit terminal 8 and ground.
    • If less than specified value, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the radio.
  4. Ignition ON, test for B+ between the battery positive voltage circuit terminal 7 and ground.
    • If less than specified value, test the voltage supply circuit for a short to ground or an open/high resistance.
  5. Ignition ON, DVD playing, test for 1-8 volts between the video bright control circuit terminal 9, and ground.
    • If greater then specified range, test the control circuit for a short to voltage. If the circuit tests normal, replace the radio.
    • If less then specified range, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the radio.
  6. Ignition ON, DVD playing, test for 0.1-3.0 volts between the video mode signal circuit terminal 10, and ground.
    • If greater then specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the radio.
    • If less then specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the radio.
  7. Ignition ON, DVD playing, test for 1-3 volts between the video signal (+) circuit terminal 1, and ground.
    • If greater then specified range, test the control circuit for a short to voltage. If the circuit tests normal, replace the radio.
    • If less then specified range, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the radio.
  8. If all circuits test normal, replace the DVD display.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.