Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Sensing and Diagnostic Module Replacement and/or Programming
If the inflatable restraint sensing and diagnostic module needs to be replaced and/or reprogrammed, the following procedures must be performed:
- Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS)
- Perform the SPS function Inflatable Restraint Sensing and Diagnostic Module - Programming and follow the on-screen instructions.
- Perform the SPS function Inflatable Restraint Sensing and Diagnostic Module - Setup and follow the on-screen instructions.
- Clear DTCs after completing the programming procedure.
If the control module fails to program, proceed as follows:
- Ensure the DLC and APM connections are good.
- Inspect the Techline equipment for the latest software version.
- Attempt to program the SDM. If the SDM still cannot be programmed properly, replace the SDM.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.