Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 GMC Acadia AWD V6-3.6LFACTORY OEM SERVICE PROCEDURE
Window Motor Programming - Express Function
Window Motor Programming - Express Function (RPO AXC/AXE)
Window Motor Programming and Setup
When replacing a window motor in the front or the rear doors the new motor must be programmed using the Tech 2.
Follow the procedure below to program power window motors.
1. Install Tech 2 and CANDI module.
2. Select proper year, make and model of vehicle.
3. Select Body and Accessories.
4. Select Doors.
5. Select Special Functions.
6. Select Drivers Door Switch or Passenger Door Switch depending on which window motor you are trying to program.
7. Select Power Window Motor Programming and follow on tool instructions.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.