2008 GMC Acadia AWD V6-3.6LFACTORY OEM SERVICE PROCEDURE

Power Seat Control Module: Locations



Passenger Compartment/Roof Component Views

Driver Seat (AG3)

Factory service manual diagram



1 - Seat Horizontal Position Sensor
2 - Seat Lumbar Vertical Motor - Driver
3 - Inflatable Restraint Side Impact Module - Left
4 - Seat Lumbar Horizontal Motor - Driver
5 - Seat Recline Motor - Driver
6 - Seat Recline Position Sensor - Driver
7 - Seat Lumbar Switch - Driver
8 - Seat Horizontal Motor - Driver
9 - Seat Adjuster Switch - Driver
10 - Inflatable Restraint Seat Position Sensor (SPS) - Driver (W49)
11 - Seat Rear Vertical Motor - Driver
12 - Seat Rear Vertical Position Sensor
13 - Seat Front Vertical Position Sensor
14 - Memory Seat Module
15 - Seat Front Vertical Motor - Driver
16 - Seat Belt Switch - Driver
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.