2007 GMC Canyon 2WD L4-2.9LFACTORY OEM SERVICE PROCEDURE

System Specifications

Crankshaft Balancer Bolt
First Pass 150 N.m 110 lb ft
Final Pass 180 degrees

Engine Front Cover Bolt 10 N.m 89 lb in
Engine Front Cover Center Bolt - Small 8 N.m 71 lb in
Engine Front Cover Spacer Bolt 10 N.m 89 lb in
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.