Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 GMC Canyon 2WD L4-2.9LFACTORY OEM SERVICE PROCEDURE
Vehicle Speed Sensor: Locations
Engine Controls Component Views
Engine Controls Components 5 of 5
Transfer Case Components:
1 - Park/Neutral Position (PNP) Switch (M30)
2 - Heated Oxygen Sensor (HO2S) 2
3 - Vehicle Speed Sensor (VSS)
4 - Transfer Case Neutral Switch (4WD)
5 - Transfer Case 2/4 Wheel Driver Indicator Switch (4WD)
6 - Transfer Case Encoder Motor (4WD)
7 - Evaporative Emission (EVAP) Canister Vent Solenoid
8 - Fuel Tank Pressure (FTP) Sensor
9 - Fuel Pump and Sender Assembly
10 - Fuel Pump
11 - Transfer Case
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
