2007 GMC Acadia AWD V6-3.6LFACTORY OEM SERVICE PROCEDURE

Engine Oil: Service and Repair



Engine Oil and Oil Filter Replacement

Removal Procedure

Factory service manual diagram



1. Raise and support the vehicle.
2. Place a drain pan under the oil pan drain plug.
3. Remove the oil pan drain plug (1). Allow the oil to drain completely.

Notice: Refer to Fastener Notice.

4. Install the oil pan drain plug (1).

Tighten the drain plug to 20 N.m (15 lb ft).

Factory service manual diagram



5. Place the drain pan under the oil filter.
6. Remove the oil filter. Allow the oil to drain completely.

Installation Procedure

Factory service manual diagram



1. Lubricate the NEW oil filter gasket with clean engine oil.
2. Tighten the oil filter.

Tighten the filter to 30 N.m (22 lb ft).

3. Lower the vehicle.
4. Fill the engine with oil to the appropriate mark.
5. Start the engine and inspect for leaks.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.