Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inflatable Restraint Sensing and Diagnostic Module Programming and Setup: Introduction
The replacement of the inflatable restraint sensing and diagnostic module (SDM) will require that the SDM part number be relearned by other modules, such as the body control module (BCM), and the powertrain control module (PCM). The following procedures are designed to setup the SDM correctly and must be performed.
- The Air Bag indicator may illuminate and DTC B1001 may set during the BCM reprogramming procedure.
- Use the 10-minute relearn procedure when programming the theft deterrent system.
- Program the BCM with the proper regular production options (RPO). Refer to Body Control Module (BCM) Programming/RPO Configuration .
- Clear any DTC.
- Perform the Diagnostic System Check - Vehicle .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.