Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2005 GMC Jimmy Part Time, StandardFACTORY OEM SERVICE PROCEDURE

Removal Procedure

Fig 1: View Of Breather Tube At Air Cleaner Outlet Duct

Courtesy of GENERAL MOTORS CORP.

Disconnect the breather tube from the air cleaner outlet duct.

Fig 2: Locating IAT Sensor Harness Connector

Courtesy of GENERAL MOTORS CORP.

Disconnect the intake air temperature (IAT) sensor harness connector.

Fig 3: Locating Cleaner Outlet Duct Retaining Wingnut

Courtesy of GENERAL MOTORS CORP.

Remove the air cleaner outlet duct retaining wingnut.

Fig 4: Air Intake Tube Routing

Courtesy of GENERAL MOTORS CORP.

Separate the air cleaner outlet duct from the air cleaner by loosening the hose clamp after the mass air flow (MAF) sensor.
Remove air cleaner outlet duct.

Chapter Navigation

Return to Chapter: Air Cleaner Outlet Resonator Replacement

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.