Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 GMC Jimmy Part Time, AutomaticFACTORY OEM SERVICE PROCEDURE
Fastener Tightening Specifications
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Ball Guide Clamp Screws | 6 N.m | 53 lb ft |
| Coupling Shield Retainer and Lock Nut | 109 N.m | 80 lb ft |
| Filler Neck Tube Bolt | 20 N.m | 15 lb ft |
| Front Differential Carrier Shield Bolts | 25 N.m | 18 lb ft |
| Hood Latch Support Mounting Bolts | 25 N.m | 18 lb ft |
| Lower Intermediate Shaft Coupling Bolt | 35 N.m | 26 lb ft |
| Pitman Arm Ball Stud to Relay Rod Nut | 83 N.m | 61 lb ft |
| Pitman Arm to Power Steering Gear Nut | 250 N.m | 184 lb ft |
| Power Steering Cooler Retaining Bolts | 10 N.m | 89 lb in |
| Power Steering Gear Adjuster Lock Nut | 44 N.m | 32 lb ft |
| Power Steering Gear Side Cover Bolts | 60 N.m | 45 lb ft |
| Power Steering Gear to Frame Mounting Bolts | 75 N.m | 55 lb ft |
| Power Steering Hose Clamps | 2 N.m | 18 lb in |
| Power Steering Pressure Hose to Power Steering Gear | 30 N.m | 22 lb ft |
| Power Steering Pressure Hose to Power Steering Pump | 25 N.m | 18 lb ft |
| Power Steering Pump Bracket Bolts and Nut | 41 N.m | 301 lb ft |
| Power Steering Pump Control Valve Fitting | 75 N.m | 55 lb ft |
| Power Steering Pump Front Mounting Bolts | 50 N.m | 37 lb ft |
| Power Steering Pump Mounting Studs | 58 N.m | 43 lb ft |
| Power Steering Pump Rear Mounting Bracket Nuts | 41 N.m | 31 lb ft |
| Power Steering Return Hose to Power Steering Gear | 25 N.m | 18 lb ft |
| Rack Piston Plug | 150 N.m | 111 lb in |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.