Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 GMC Jimmy Part Time, AutomaticFACTORY OEM SERVICE PROCEDURE
Engine Electrical Component Views
| Callout | Component Name |
|---|---|
| 1 | Radiator Support |
| 2 | Battery (2.2 L Engine shown, 4.3 L Engine similar) |
| 3 | Battery Tray |
| Callout | Component Name |
|---|---|
| 1 | Radiator Support |
| 2 | Battery Fuse |
| 3 | G108 |
| 4 | S153 |
| Callout | Component Name |
|---|---|
| 1 | Exhaust Gas Recirculation (EGR) Valve |
| 2 | Generator Connector |
| 3 | Crankshaft Position (CKP) Sensor |
| 4 | Starter |
| 5 | Starter Solenoid |
| 6 | Splice S100 |
| 7 | Splice S101 |
| 8 | Splice S102 |
| 9 | Ignition Control Module (ICM) |
| 10 | Ignition Coil |
| 11 | Ignition Coil Assembly |
| 12 | G107 |
| Callout | Component Name |
|---|---|
| 1 | Dash Panel |
| 2 | Stoplamp Switch |
| 3 | Brake Pedal |
| 4 | Manual Transmission Clutch Start Switch |
| 5 | Clutch Pedal |
| Callout | Component Name |
|---|---|
| 1 | Oxygen Sensor (O2S), Bank 1 Sensor 1 and Connector |
| 2 | Engine Harness |
| 3 | Starter Solenoid |
| 4 | Starter |
| 5 | Exhaust Manifold |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
