Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2005 GMC Jimmy Part Time, AutomaticFACTORY OEM SERVICE PROCEDURE

Installation Procedure

Fig 1: View Of Memory Seat Control Module

Courtesy of GENERAL MOTORS CORP.

Slide the memory seat module into the bracket until the module is seated.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the memory seat module and bracket to the seat adjuster frame assembly with 2 screws.
Tighten: Tighten the screws to 3 N.m (26 lb in).

Fig 2: View Of Memory Seat Module Harness Connectors

Courtesy of GENERAL MOTORS CORP.

Install the memory seat module harness connectors.
Install the front seat to the vehicle. Refer to Seat Replacement - Bucket .
Calibrate the seat. Refer to Memory Seat Calibration Procedure .

Chapter Navigation

Return to Chapter: Memory Seat Control Module Replacement

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.