2004 GMC Jimmy 2D Utility, Part Time, AutomaticFACTORY OEM SERVICE PROCEDURE

Fuel System Cleaning

    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable.
  2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure .
  3. Drain the fuel tank. Refer to Fuel Tank Draining Procedure (2-Door Utility) .
  4. Remove the fuel tank. Refer to Fuel Tank Replacement (Pickup) , Fuel Tank Replacement (2-Door Utility)  or Fuel Tank Replacement (4-Door Utility) .
  5. Remove the fuel sender assembly. Refer to Fuel Sender Assembly Replacement (Utility/Crew Cab)  or Fuel Sender Assembly Replacement (Pick-Up) .
  6. Inspect the fuel strainer. Replace a contaminated strainer and inspect the fuel pump.
  7. Inspect the fuel pump inlet for dirt and debris. Replace the fuel pump if you find dirt or debris in the fuel pump inlet.
    8. IMPORTANT: When flushing the fuel tank, handle the fuel and water mixture as a hazardous material. Handle the fuel and water mixture in accordance with all applicable local, state and federal laws and regulations.
  8. Flush the fuel tank with hot water.
  9. Pour the water out of the fuel sender assembly opening.
  10. Rock the tank to be sure that removal of the water from the tank is complete.
  11. Inspect the in-line fuel filter for contamination.
  12. Replace the fuel filter if the filter is plugged. Refer to Fuel Filter Replacement .
    13. IMPORTANT: Only use oil free compressed air to blow out the fuel pipes.
  13. Clean the fuel pipes by applying air pressure in the opposite direction of the fuel flow.
  14. Install the fuel sender assembly with a new seal into the fuel tank. Refer to Fuel Sender Assembly Replacement (Utility/Crew Cab)  or Fuel Sender Assembly Replacement (Pick-Up) .
  15. Install the fuel tank. Refer to Fuel Tank Replacement (Pickup) , Fuel Tank Replacement (2-Door Utility)  or Fuel Tank Replacement (4-Door Utility) .
  16. Refill the fuel tank.
  17. Install the fuel filler cap.
  18. Connect the negative battery cable.
  19. Inspect for leaks.
    1. Turn ON the ignition for 2 seconds.
    2. Turn OFF the ignition for 10 seconds.
    3. Turn ON the ignition.
    4. Inspect for fuel leaks.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.