Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 GMC Jimmy 2D Utility, Part Time, AutomaticFACTORY OEM SERVICE PROCEDURE
Cleaning Procedures
- Disconnect negative battery cable.
- Relieve fuel system pressure. Refer to FUEL SYSTEM PRESSURE RELEASE under FUEL SYSTEMS in BASIC DIAGNOSTIC PROCEDURES - 4.3L ASTRO, BLAZER, JIMMY CANADIAN, SAFARI, SONOMA & S10 PICKUP article.
- Drain fuel tank.
- Remove fuel tank.
- Remove fuel sender assembly.
- Inspect fuel strainer. Replace a contaminated strainer and inspect fuel pump.
- Inspect fuel pump inlet for dirt and debris. Replace fuel pump if you find dirt or debris in fuel pump inlet.
- Flush fuel tank with hot water.
- Pour water out of fuel sender assembly opening.
- Rock the tank to be sure that removal of the water from tank is complete.
- Inspect the in-line fuel filter for contamination.
- Replace fuel filter, if plugged.
NOTE:
When flushing fuel tank, handle fuel and water mixture as a hazardous material. Handle fuel and water mixture in accordance with all applicable local, state and federal laws and regulations.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.