Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 GMC Jimmy 2D Utility, Part Time, AutomaticFACTORY OEM SERVICE PROCEDURE
Starter Motor: Installation
- Connect the wires to the solenoid. Tighten the battery positive cable nut and the engine wiring harness to starter nut to specifications. See TORQUE SPECIFICATIONS .
- Install the starter and the inboard starter mounting bolt. Do not tighten. Install the starter shims, if equipped. Install the outboard starter mounting bolt. Tighten the starter mounting bolts to specifications. See TORQUE SPECIFICATIONS .
- Install the differential carrier shield, if equipped. Install the differential carrier shield mounting bolts. Tighten the differential carrier bolts to specifications. See TORQUE SPECIFICATIONS .
- Lower the vehicle. Connect the battery negative cable. Tighten battery cable to specifications. See TORQUE SPECIFICATIONS .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.