2003 GMC Jimmy 2D Utility, Part Time, AutomaticFACTORY OEM SERVICE PROCEDURE

Installation Procedure

Important:  Do not reuse the old mounting screws. Always install new mounting screws with the new EBCM.

Important:  Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.

  1. Install EBCM (2) on to the BPMV (3).
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the four new T-25 TORX® screws (1) in the EBCM (2).

    Tighten 

    Tighten the four T-25 TORX® screws to 5 N.m (39 lb in) in an X-pattern.

  3. Connect the electrical connectors to the EBCM (2).
  4. Revise the tire calibration using the Scan Tool Tire Size Calibration function.
    Fig 1: Installing EBCM
    G01468871Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.