2003 GMC Jimmy 2D Utility, Part Time, AutomaticFACTORY OEM SERVICE PROCEDURE

Installation Procedure

  1. Slide the memory seat module into the bracket until the module is seated.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the memory seat module and bracket to the seat adjuster frame assembly with 2 screws.

    Tighten 

    Tighten the memory seat module retaining screws to 3 N.m (26 lb in).

    Fig 1: Installing Memory Seat Module & Bracket To Seat Adjuster Frame Assembly With Screws
    G01478079Courtesy of GENERAL MOTORS CORP.
  3. Install the memory seat module harness connectors.
  4. Install the front seat to the vehicle. Refer to SEAT REPLACEMENT - Bucket .
    Fig 2: Memory Seat Module Harness Connectors
    G01478080Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.