2002 GMC Jimmy 2D Utility, Part Time, AutomaticFACTORY OEM SERVICE PROCEDURE

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable.
  2. Remove the right upper quarter panel trim. Refer to Trim Panel Replacement- Rear Quarter Upper in Interior Trim.
  3. Fig 1: Remote Control Door Lock Receiver, Electrical Connector And Bolt
    GM860850Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the remote control door lock receiver electrical connector (2).
  5. Remove the bolt (3) from the remote control door lock receiver (1).
  6. Remove the remote control door lock receiver (1) from the vehicle.
  7. Fig 2: Remote Control Door Lock Receiver & Mounting Bracket
    GM860853Courtesy of GENERAL MOTORS CORP.
  8. Using a flat bladed tool, remove the mounting bracket (1) from the receiver (2), if necessary.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.