Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 GMC Jimmy 2D Utility, Part Time, AutomaticFACTORY OEM SERVICE PROCEDURE
Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Instal the remote control door lock receiver (2) to the mounting bracket (1), if removed.
- Install the remote control door lock receiver (1) to the vehicle.
- Install the bolt (3) to the door lock receiver (1).
Tighten: Tighten the remote control door lock receiver bolt to 10 N.m (89 lb in).
- Connect the remote control door lock receiver electrical connector (2).
- Install the right upper quarter panel trim. Refer to Trim Panel Replacement- Rear Quarter Upper in Interior Trim.
- Connect the negative battery cable.
- Reprogram the remote control door lock receiver, if necessary. Refer to Transmitter Programming in Keyless Entry.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.