Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 GMC Jimmy 2D Utility, Part Time, AutomaticFACTORY OEM SERVICE PROCEDURE
Control Module References
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
Control Module References
| Control Module | Repair Instructions | Diagnostic System Check | Schematic |
|---|---|---|---|
| BPMV | Refer to Brake Modulator Assembly Replacement in Antilock Brake System | Refer to Diagnostic System Check - ABS in Antilock Brake System | Refer to ABS Schematics in Antilock Brake System |
| PCM | Refer to Powertrain Control Module (PCM) Replacement
in Engine Controls - 1.8 L (LV6) or Powertrain Control Module (PCM) Replacement in Engine Controls - 1.8 L (LNK) |
Refer to Diagnostic System Check - Engine Controls
in Engine Controls - 1.8 L (LV6) or Diagnostic System Check - Engine Controls in Engine Controls 1.8 L (LNK) |
Refer to Engine Controls Schematics
in Engine Controls - 1.8 L (LV6) or Engine Controls Schematics in Engine Controls 1.8 L (LNK) |
| SDM | Refer to Inflatable Restraint Sensing and Diagnostic Module Replacement in SIR | Refer to Diagnostic System Check - SIR in SIR | Refer to SIR Schematics in SIR |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.