2002 GMC Jimmy 2D Utility, Part Time, AutomaticFACTORY OEM SERVICE PROCEDURE

Removal Procedure

IMPORTANT: The ignition switch should be in the OFF position when connecting or disconnecting the connectors to the BCM. Always disconnect the Brown BCM connector FIRST and connect the Brown BCM connector LAST. The BCM can set DTC(s) with the ignition switch in the OFF position.
  1. Remove the left instrument panel sound insulator from the vehicle. Refer to CLOSEOUT/INSULATOR PANEL REPLACEMENT - LEFT in INSTRUMENT PANEL, GAGES & CONSOLE article.
  2. Remove the lower instrument panel sound insulator from the vehicle. Refer to CLOSEOUT/INSULATOR PANEL REPLACEMENT - IP LOW in INSTRUMENT PANEL, GAGES & CONSOLE article.
  3. Disconnect the electrical connectors from the body control module.
  4. Bend the 2 snap retainers back slightly and pull the body control module from the bracket at an angle.
    Fig 1: Locating Body Control Module Replacement
    G01841077Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.