2002 GMC C3500 HD 8.1 G, AutomaticFACTORY OEM SERVICE PROCEDURE

Installation Procedure

  1. Install the fuel tank insulators.
    Fig 1: Fuel Tank Insulators
    G01598916Courtesy of GENERAL MOTORS CORP.
  2. Install the fuel sender. Refer to Fuel Sender Assembly ReplacementΒ .
  3. Raise the fuel tank.
  4. Connect the fuel pipes (1,3) and the vapor pipe (2) to the fuel sender.
  5. Connect the electrical connections at the sender.
    Fig 2: Fuel Pipes & Fuel Vapor Pipe
    G01598917Courtesy of GENERAL MOTORS CORP.
  6. Raise the fuel tank and shield fully.
    Fig 3: Fuel Tank & Shield
    G01598918Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.