2002 GMC C3500 HD 8.1 G, AutomaticFACTORY OEM SERVICE PROCEDURE

Removal Procedure

NOTE: Use care in removing the fuel injectors in order to prevent damage to the fuel injector electrical connector pins or the fuel injector nozzles. Do not immerse the fuel injector in any type of cleaner. The fuel injector is an electrical component and may be damaged by this cleaning method.

Important:Β  The engine oil may be contaminated with fuel if the fuel injectors are leaking.

  1. Remove the fuel rail assembly. Refer to Fuel Rail Assembly ReplacementΒ .
  2. Remove the injector retainer clip (4).
  3. Insert the fork of J 43013Β  the fuel injector assembly removal tool between the fuel rail pod and the 3 protruding retaining clip ledges. Use a prying motion while inserting the tool in order to force the injector out of the fuel rail pod.
    Fig 1: Fuel Injector & Retainer Clip
    G01598972Courtesy of GENERAL MOTORS CORP.
  4. Discard the injector retainer clip (1).
  5. Remove the injector O-ring seals (2), (4) from both ends of the injector. Discard the O-ring seals.
    Fig 2: Injector Retainer Clip, O-Ring Seals & Injector
    G01598973Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.