2002 GMC C3500 HD 6.5 F, AutomaticFACTORY OEM SERVICE PROCEDURE

Removal Procedure

  1. Loosen the upper intake manifold cover bolts.
  2. Remove the upper intake manifold cover.
    Fig 1: Upper Intake Manifold Cover & Bolts
    G01599481Courtesy of GENERAL MOTORS CORP.
  3. Open the air bleed valve on top of the fuel manager/filter to release any pressure in the fuel supply system.
    Fig 2: Opening Air Bleed Valve
    G01599482Courtesy of GENERAL MOTORS CORP.
  4. Remove the mounting bolts that connect the fuel manager/filter to the intake manifold.
    Fig 3: Fuel Manager/Filter Mounting Bolts
    G01599483Courtesy of GENERAL MOTORS CORP.
  5. Remove the wiring harnesses and the fuel hoses.
  6. Remove the fuel manager/filter by lifting straight up.
    Fig 4: Fuel Manager/Filter
    G01599484Courtesy of GENERAL MOTORS CORP.
  7. Remove the sensor mounting screws.
    Fig 5: Water-In-Fuel Sensor Mounting Screws
    G01599485Courtesy of GENERAL MOTORS CORP.
  8. Remove the sensor.
    Fig 6: Water-In-Fuel Sensor
    G01599486Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.