Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 GMC C3500 HD 6.5 F, AutomaticFACTORY OEM SERVICE PROCEDURE
Removal Procedure
CAUTION:
Refer to BATTERY DISCONNECT CAUTION
.
- Remove the negative battery cables.
- Remove the fuel from the tank. Refer to Fuel Tank Draining Procedure .
- Remove the fuel tank. Refer to Fuel Tank Replacement (Extended Cab Side Tank) or Fuel Tank Replacement (Pickup Side Tank) or Fuel Tank Replacement (Cab and Chassis Rear Tank) or Fuel Tank Replacement (Cab and Chassis Side Tank) .
- Remove the fuel sender. Refer to Fuel Sender Assembly Replacement .
- Clean the fuel tank.
Important: The fuel tank should be replaced if the tank is rusted internally.
- Remove the fuel strainer or replace if necessary. Refer to Fuel Sender Assembly Replacement .
- Remove the fuel lift pump. Refer to Fuel Pump Replacement .
- Remove the fuel manager/filter. Refer to Fuel Filter/Heater Element Housing Replacement .
- Remove the fuel return line at the injection pump.
- Use low air pressure to blow out the lines toward the rear of the vehicle.
- Replace the pipes if they are rusted internally.
- Remove the fuel filter from the fuel manager housing. Refer to Fuel Filter Replacement .
- Wipe out the inside of the housing with a clean towel.
- Remove the heater element from the housing. Refer to Fuel Heater Element Replacement .
- Remove the water in fuel sensing element from the housing. Refer to Water-in-Fuel Sensor Replacement .
- Clean the inside of the filter housing with GM brake parts cleaner or equivalent.
- Dry the housing completely.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
