Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 GMC C3500 HD 6.5 F, AutomaticFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- Install the new O-ring on the ESO solenoid.NOTE: Refer to COMPONENT FASTENER TIGHTENING NOTICE .
- Install the ESO solenoid in the injection pump.
Tighten
Tighten the solenoid (external hex or internal hex) to 25 N.m (18 lb ft).
- Install the ESO electrical connector.
- Start the engine and check for leaks.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
