Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2002 GMC C3500 HD 6.5 F, AutomaticFACTORY OEM SERVICE PROCEDURE

Installation Procedure

Install the air inlet elbow on the filter by pushing on the inlet elbow.
Install the air cleaner filter with the air inlet elbow attached into the housing.
Install the MAF sensor electrical connector (L56 only).

Fig 1: MAF Sensor Electrical Connector (L56 Only)
Courtesy of GENERAL MOTORS CORP.
Install the air cleaner cover into the housing and clip into place.

Fig 2: Air Cleaner Cover
Courtesy of GENERAL MOTORS CORP.
Install the air cleaner inlet elbow into the turbocharger inlet elbow.
NOTE: Refer to FASTENER NOTICE .
Tighten the elbow clamp.
Tighten

Tighten the elbow clamp to 5 N.m (44 lb in).

Fig 3: Air Cleaner Inlet Elbow
Courtesy of GENERAL MOTORS CORP.

Chapter Navigation

Return to Chapter: Air Cleaner Element Replacement

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.