Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 GMC C3500 HD 6.5 F, AutomaticFACTORY OEM SERVICE PROCEDURE
Removal Procedure
CAUTION:
Replace the O-ring seals exposed during component service in order to reduce the risk of fire and personal injury that may result from a fuel leak.
- Remove negative battery cables.
- Loosen filler caps to relieve tank pressure.
- Release the fuel pump electrical connector.
- Clean both fuel line connections and surrounding areas at fuel pump before disconnecting to avoid possible contamination of the fuel system.
- Remove both fuel lines from fuel pump by loosening the fuel line fittings.
- Slide fuel pump out of bracket.
CAUTION:
Refer to Battery Disconnect Caution in Cautions and Notices.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
