Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
- Install the injection lines at the pump. Refer to Fuel System Description .
- Uncap the lines and pump fittings.
- Refer to the tags for the correct installation.
- Install the injection lines at the nozzles.
- Uncap the lines and the nozzles.
Tighten: Tighten the fittings to 25 N.m (18 lb ft).
- Install the injection line clips at the loom brackets.
- Remove the J 39664 manifold cover set. See Special Tools .
- Install the intake manifold. Refer to Intake Manifold Installation - Lower) and Intake Manifold Installation - Upper) in Engine Mechanical - 6.5L.
- Install the negative battery cables.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.