2000 GMC Yukon DenaliFACTORY OEM SERVICE PROCEDURE

Asleep & Awake Functions

After the ignition switch is turned off and 20 minutes elapse without any wake up signals, the BCM enters an asleep state and goes into the low power mode. Wake up signals turn BCM on to begin controlling and/or monitoring of certain functions. BCM wake-up inputs are as follows:

  • Door ajar switches.
  • Door handle switches.
  • Dome light.
  • Parking Lights.
  • Power door lock switches.
  • Interior light request active.
  • Ignition key put into ignition switch.
  • Ignition key removed from ignition switch.
  • Ignition turned on.
  • Key in door lock switch.
  • Remote Function Actuator (RFA) request to BCM.
  • Any class 2 communication requiring BCM interaction.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.