Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 GMC EnvoyFACTORY OEM SERVICE PROCEDURE
Diagnostic Procedures
- Perform On-Board Diagnostic (OBD) system check. See ON-BOARD DIAGNOSTIC SYSTEM CHECK . After performing OBD system check, go to next step.
- Replace VCM. Program replacement VCM using required equipment and perform Crankshaft Variation Learn Procedure. After replacing VCM, go to next step.
- Using scan tool, select DTC and CLEAR DTC INFO function. Warm engine to normal operating temperature. Operate engine at idle. Using scan tool, select DTC and SPECIFIC DTC function, then enter this DTC. Operate vehicle within conditions for setting this DTC. If scan tool indicates that this DTC ran and passed, go to next step. If scan tool does not indicate that this DTC ran and passed, repeat step 2.
- Check if any additional DTC(s) are present. If additional DTCs are present, diagnose affected DTC(s) first. If no other DTCs are present, system is okay.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.