Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 GMC EnvoyFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Miscellaneous
MISCELLANEOUS
| Component | Component Location |
|---|---|
| A/C Compressor Clutch Diode (2.2L VIN 4) | In A/C compressor wire harness, between A/C compressor & engine harness breakout. See Figure . |
| A/C Compressor Clutch Diode (4.3L VIN W) | In A/C compressor clutch wire harness, behind compressor. |
| A/C Compressor Clutch Diode (4.3L VIN X) | In A/C compressor clutch wire harness, behind compressor. |
| Blower Motor Resistor | On right rear of engine compartment, on blower module. |
| Data Link Connector (DLC) | Under left side of dash. |
| Distributor (4.3L VIN W) | Top rear of engine. |
| Distributor (4.3L VIN X) | Top rear of engine. |
| Fuel Injectors (2.2L VIN 4) | On top of engine, at intake ports. |
| Fuel Injectors (4.3L VIN W) | On top of engine, at intake ports. |
| Fuel Injectors (4.3L VIN X) | On top of engine, at intake ports. |
| Fuel Pump Prime Connector | In underhood fuse block. |
| High Mount Stoplamp Resistor | In body harness 10 cm before breakout to high mounted stoplamps. |
| Ignition Coil (2.2L VIN 4) | On right side of engine. |
| Ignition Coil (4.3L VIN W) | On top right side of engine. See Figure . |
| Ignition Coil (4.3L VIN X) | On top right side of engine. See Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.