Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
BCM Programming/Regular Production Option Codes
BCM must be programmed with proper Regular Production Option (RPO) configurations. If BCM is not properly programmed with correct RPO codes, the BCM will not be able to control the features properly. Before programming BCM ensure battery is fully charged, ignition is turned on and Data Link Connector (DLC) is accessible. Follow instructions on scan tool to program BCM. If BCM fails to accept programming or RPO codes, check connections at BCM and ensure scan tool has latest software updates. When BCM is replaced, Passlock™ must also be reprogrammed. See PASSLOCK™ LEARN PROCEDURES.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.