2000 GMC C3500 HD 6.5 F, AutomaticFACTORY OEM SERVICE PROCEDURE

Diagnostic Procedure

Diagnosis of computerized engine control system should be performed in the following order:

  1. Ensure all engine systems not related to computer are operating properly. Check for any Technical Service Bulletins (TSB) that may apply. DO NOT proceed with testing unless all other problems have been repaired. Perform OBD system check before diagnosing Diagnostic Trouble Codes (DTC). See ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECKΒ .
  2. If DTC were displayed, determine whether DTCs are hard or intermittent. Hard DTCs will cause MIL to illuminate continuously while engine is running. See HARD OR INTERMITTENT TROUBLE CODE DETERMINATIONΒ . For diagnosing hard DTCs, perform appropriate DTC test. See DIAGNOSTIC TESTSΒ . For diagnosing intermittent DTCs, see INTERMITTENTS in appropriate TROUBLE SHOOTING - NO CODES article.
  3. If no DTCs are set and a driveability problem exists, see SYMPTOMS in appropriate TROUBLE SHOOTING - NO CODES article. Doing so will help identify proper system or component to check. See appropriate SYSTEM & COMPONENT TESTING article for diagnosis of faulty component.
  4. After necessary repairs are made, clear DTCs, verify vehicle will enter "closed loop" operation, and ensure no DTCs set.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.