Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 GMC C3500 HD 6.5 F, AutomaticFACTORY OEM SERVICE PROCEDURE
Fuel Pump Balance Module: Installation
- Remove caps from the fuel pipes.
- Install new pipe O-rings.
- Position the new pump in the pump bracket.
- Connect fuel feed pipe and suction pipe to the fuel pump. Use a backup wrench to prevent the pump from turning. Tighten the fittings to 22 ft. lbs. (30 N.m).
- Connect electrical connector.
- Lower vehicle.
- Tighten fuel filler cap.
- Connect negative battery cable.
- Turn ON ignition for 2 seconds. Turn OFF ignition for 10 seconds. Turn ON ignition. Inspect for fuel leaks.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
