Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 GMC C3500 HD 6.5 F, AutomaticFACTORY OEM SERVICE PROCEDURE
Component Locations
NOTE:
Component location illustrations are not available at time of publication.
COMPONENT LOCATIONS (VIN F & S)
| Component | Location |
|---|---|
| A/C Compressor Relay | In Power Distribution Box At Left Rear Of Engine Compartment |
| A/C Low Pressure Cutoff Switch | Top Of Compressor, In High Pressure Refrigerant Line |
| A/C High Pressure Cut-Off Switch | On Rear Of A/C Compressor |
| Balance Fuel Pump | On Inside Left Frame Rail, Near Front Of Rear Tank |
| Balance Fuel Pump Relay | On Balance Fuel Pump |
| Crankshaft Position (CKP) Sensor | Lower Left Front Of Engine, Near Crankshaft Pulley |
| Data Link Connector (DLC) | Under Left Side Of Instrument Panel |
| EGR Control Pressure/Baro Sensor | On Bulkhead To Right Of Steering Column |
| EGR Solenoid | Left Rear Top Of Engine, Above Valve Cover |
| Electronic Fuel Injection Pump | Top Of Engine, Near ECT Sensor |
| Engine Coolant Temperature (ECT) Sensor | Lower Front Of Engine |
| Fuel Pump Oil Pressure Switch | Under Intake Manifold, At Center Of Engine |
| Fuel Pump Prime Connector | At Instrument Panel Harness, Near instrument Panel Fuse Box |
| Fuel Pump Relay | In Power Distribution Box |
| Glow Plug Relay | Left Rear Of Engine, Near Bulkhead |
| Intake Air Temperature (IAT) Sensor | On Air Intake Duct |
| Mass Airflow (MAF) Sensor | On Air Intake Duct |
| Power Distribution Box | Left Rear Of Engine Compartment, On Wheelwell |
| Powertrain Control Module (PCM) | Under Right Side Of Instrument Panel, Above Blower Motor |
| Wastegate Solenoid | Left Rear Top Of Engine, Above Valve Cover |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
