1997 GMC C3500 HD 6.5 F, AutomaticFACTORY OEM SERVICE PROCEDURE

Window Switch Does Not Illuminate

  1. Put headlight and panel dimmer switch in PARK position. Disconnect suspect window switch. Connect test light between Brown wire and ground. If test light illuminates, go to next step. If test light does not illuminate, repair open in Brown wire.
  2. Connect test light between Brown and Black wires. If test light does not illuminate, repair open in Black wire. If test light illuminates, replace suspect switch.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.