Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 GMC Yukon 2WD V8-5.7L VIN RFACTORY OEM SERVICE PROCEDURE
EEPROM Programming
CAUTION: The ignition should always be "off" when installing or removing the Vehicle Control Module (VCM) connectors.
1. Set-up:
^ Battery is charged.
^ Ignition is "ON."
^ Battery/cig. lighter Connection secure.
^ Data Link Connector (DLC).
2. Refer to up-to-date Techline terminal/equipment user's instructions.
3. If Vehicle Control Module (VCM) fails to program, do the following:
^ Check all VCM connections.
^ check Techline terminal/equipment for latest software version.
^ Try again to program the VCM. If it fails again, replace the VCM. Refer to VCM replacement. Control Module Replacement
4. Perform the Idle Air Control (IAC) valve reset procedure with the scan tool. use misc. test.
5. For a functional check perform one of the steps:
^ Use the Techline terminal and equipment in order to perform the On-Board Diagnostic (OBD) System Check
^ Refer to Powertrain OBD System Check. Testing and Inspection
1. Set-up:
^ Battery is charged.
^ Ignition is "ON."
^ Battery/cig. lighter Connection secure.
^ Data Link Connector (DLC).
2. Refer to up-to-date Techline terminal/equipment user's instructions.
3. If Vehicle Control Module (VCM) fails to program, do the following:
^ Check all VCM connections.
^ check Techline terminal/equipment for latest software version.
^ Try again to program the VCM. If it fails again, replace the VCM. Refer to VCM replacement. Control Module Replacement
4. Perform the Idle Air Control (IAC) valve reset procedure with the scan tool. use misc. test.
5. For a functional check perform one of the steps:
^ Use the Techline terminal and equipment in order to perform the On-Board Diagnostic (OBD) System Check
^ Refer to Powertrain OBD System Check. Testing and Inspection
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.