1996 GMC Jimmy 4D Utility, AWDFACTORY OEM SERVICE PROCEDURE

Automatic Transmissions DTCS

AUTOMATIC TRANSMISSIONS DTCS

DTC Description
P0502 Vehicle Speed Sensor Circuit (Low Input)
P0560 System Voltage Malfunction
P0712 Trans. Fluid Temp. (TFT) Sensor Circuit (Low Input)
P0713 Trans. Fluid Temp. (TFT) Sensor Circuit (High Input)
P0719 Brake Switch Circuit Low Input (Switch Stuck On)
P0724 Brake Switch Circuit High Input (Switch Stuck Off)
P0742 TCC Circuit Inoperative (Stuck On)
P0748 Pressure Control Solenoid Electrical Malfunction
P0751 1-2 Shift Solenoid ("A") Performance Malfunction
P0753 1-2 Shift Solenoid ("A") Electrical Malfunction
P0756 2-3 Shift Solenoid ("B") Performance Malfunction
P0758 2-3 Shift Solenoid ("B") Electrical Malfunction
P1810 Transmission Fluid Pressure (TFP) Switch Malfunction
P1812 Transmission Fluid Overtemp.
P1860 TCC Pulse Width Modulated (PWM) Solenoid Electrical Malfunction
P1864 TCC Solenoid Electrical Malfunction
P1870 Transmission Component Slipping
P1875 4WD-Low Circuit Malfunction
P1886 3-2 Shift Solenoid Electrical Malfunction
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.