1995 GMC Forward Control 7.4 NFACTORY OEM SERVICE PROCEDURE

Repair and Diagnosis: Transmission: Clutches: Description

The hydraulic clutch consists of a clutch plate, pressure plate and pilot bearing. Hydraulic clutch has a master cylinder with a reservoir. Clutch pedal moves master cylinder push rod, and a slave (actuator) cylinder at bellhousing moves clutch fork and release bearing. See Fig 1 .

Hydraulic clutch system provides automatic clutch adjustment. No adjustment of clutch linkage or pedal position is required.

Fig 1: Exploded View Of Clutch Assembly & Pilot Bearing (Typical)
G95E27098Courtesy of GENERAL MOTORS CORP.

The hydraulic line joining master cylinder to actuator cylinder has a coupling located near left rear of engine. This coupling contains internal check valves that allow master cylinder half of system to be disconnected from actuator half without loss of fluid. The coupling can be reconnected and no bleeding is required. service replacement master and actuator cylinder components are furnished pre-filled with fluid. See Fig 2 .

Fig 2: Identifying Commercial Van Clutch Hydraulic System
G94E65429Courtesy of GENERAL MOTORS CORP.
TRANSMISSION APPLICATION

Vehicle Model Transmission Model (RPO)
Commercial Van NVG 4500 109mm 5-Speed O/D (MT8)
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.