1995 GMC Forward Control 7.4 NFACTORY OEM SERVICE PROCEDURE

Body Control System Connectors

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, 1995 Dodge Caravan, and 1995 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For terminal identification of body control system connectors, see Fig 1 -21. Connector terminal numbers are molded into connectors. If connector terminal identification differs from what is shown in figure, use wire colors to ensure correct circuit is being tested. For wiring diagrams, see WIRING DIAGRAMSΒ  section at the end of this article.
CONNECTOR IDENTIFICATION

Connector See
Body Control Module
Blue Fig. Fig 1
Natural Fig. Fig 2
CCD BUS Data Link Fig. Fig 3
Compass/Mini-Trip Module Fig. Fig 4
Front & Side Door Jamb Switch Fig. Fig 5
Fuel Pump/Sending Unit Fig. Fig 6
Instrument Cluster Fig. Fig 7
Ignition Key In Ignition Switch Fig. Fig 8
Left Pod Switch Assembly Fig. Fig 9
Left Pod Switch Connectors
Black Fig. Fig 10
Blue & Gray Fig. Fig 11
Liftgate Switch Fig. Fig 12
Multifunction Switch Fig. Fig 13
Powertrain Control Module (PCM) Fig. Fig 14
Radio Connectors
Black Fig. Fig 15
Gray Fig. Fig 16
Relay Block Fig. Fig 17
Remote Keyless Entry (RKE) Module Fig. Fig 18
Speaker Connectors
Door Fig. Fig 19
Rear Fig. Fig 20
Fig 1: Blue Body Control Module Connector Terminal ID (All Models)
G95H27190Courtesy of CHRYSLER CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.