Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 GMC Forward Control 7.4 NFACTORY OEM SERVICE PROCEDURE
To Decrease Speed
WARNING: This page is about a different car, the 1995 Dodge Ram Wagon and 1995 Dodge Ram Van. However, it is still accessible from the selected car via links, so may be relevant.
With cruise control system on, decrease set speed by pressing SET/DECEL or SET/COAST button. Vehicle speed will gradually decrease. Releasing button will set a new speed as long as vehicle speed is still more than 35 MPH.
NOTE:
Cruise control system will automatically disengage when vehicle speed drops to less than 35 MPH or rises to more than 85 MPH.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
