1995 GMC Forward Control 7.4 NFACTORY OEM SERVICE PROCEDURE

Section 149 (Cruise Control System): Description

WARNING: This page is about a different car, the 1995 Dodge Pickup and 1995 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

The speed (cruise) control system is electronically controlled and vacuum operated. System is electronically controlled by Powertrain Control Module (PCM). System consists of PCM, servo, speed control switch, vacuum reservoir, brake switch, vehicle distance (speed) sensor, and park/neutral position switch (automatic transmission). System controls are located on the steering wheel and consist of ON/OFF, RESUME/ACCEL, and SET/DECEL or SET/COAST buttons.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.