1994 GMC Forward Control 7.4 NFACTORY OEM SERVICE PROCEDURE

Powertrain Control Module (Pcm): Mem-Cal: Installation

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1994 GMC Yukon, 1994 GMC Suburban, 1994 GMC Pickup, 1994 GMC Cab & Chassis, and 1994 GMC C3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Carefully align MEM-CAL pins with PCM pin holes. DO NOTΒ  press in middle of MEM-CAL. Push downward evenly on ends of MEM-CAL until retaining clips on ends of MEM-CAL snap into place.
  2. Install PCM. Reconnect negative battery cable. Turn ignition on and ground DLC terminal "B". Code 12 should be flashed at least 4 times. If Code 12 is not flashed at least 4 times, other codes are present. If Code(s) 51 or 52 are present, or if CHECK ENGINE light stays on constantly with code(s) present, MEM-CAL is not fully seated, or is defective.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.