1993 GMC Yukon AutomaticFACTORY OEM SERVICE PROCEDURE

Door Module: Installation

  1. Install module and glass assembly into the door. See Figure . Fit the glass into the rear channel in the door.
  2. Install upper run channel bolt and tighten it.
  3. Connect lock and handle rods to the back of the module.
  4. Connect wiring connector if present. Pull the wiring through the boot and connect it inside the door hinge pillar.
  5. Install new water deflector. Refer to WATER DEFLECTORΒ  .
  6. Install top front and the top rear module screws.
  7. Install module to door screws.
  8. Install lower run channel bolt.
  9. Install door trim panel. Refer to DOOR TRIM PANELΒ  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.