Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 GMC Jimmy TyphoonFACTORY OEM SERVICE PROCEDURE
Component Locations
COMPONENT LOCATIONS
| Component | Location | |
|---|---|---|
| Bus Bar Ground | On Steering Column Bracket | |
| Cigarette Lighter Accessory Sockets (2) | In Front Of Console | |
| Door Lock Relay | Behind LH Side Of I/P, On RH Side Of Steering Column Support Bracket | |
| Fuse Block | Behind LH Side Of I/P | |
| Keyless Entry Module | Under Console | |
| LH Front Door Lock Motor | Front Center Of LH Door | |
| LH Front Door Lock Switch | Top Of LH Door Below Window | |
| LH Rear Door Lock Motor | Front Center Of LH Door | |
| RH Front Door Lock Motor | Front Center Of LH Door | |
| RH Front Door Lock Switch | Top Of RH Door, Below Window | |
| RH Rear Door Lock Motor | Front Center Of RH Door | |
| Connectors | ||
| C206A | Behind LH Side Of I/P, Above Brake Pedal Support Bracket | |
| C293 | Behind LH Side Of I/P | |
| C294 | Behind RH Side Of I/P | |
| C295 | Behind RH Side Of I/P | |
| C323 | Below Center Of I/P | |
| C371 | RH B-Pillar | |
| C373 | LH B-Pillar | |
| Grommets | ||
| P300 | LH A-Pillar | |
| P301 | Front Of RH Door, At RH A-Pillar | |
| P500 | LH Front Door | |
| P501 | LH Rear Door | |
| P600 | RH Front Door | |
| P601 | RH Rear Door | |
| Splices | ||
| S233 | Behind Center Of I/P | |
| S234 | Behind Center Of I/P | |
| S235 | Behind Center Of I/P | |
| S236 | Behind Center Of I/P Near Bus Bar Ground | |
| S253 | Behind Center Of I/P, Above Fuse Block | |
| S325 | Under Console | |
| S326 | Under Console | |
| S327 | Under Console | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
